Temperature Sensor DHT11, Arduino & Serial Monitor |full explanation| (A...

-

Comments

  1. Kunjesh25 August 2018 at 16:05

    Plz make more video on arduino..
    And also on temp006 tempratempe sensor..

    ReplyDelete

Post a Comment

Popular

Bidirectional Visitor Counter Project with Arduino UNO

-
Image
Code #include<LiquidCrystal.h> LiquidCrystal lcd(2,3,4,5,6,7); #define in 8 #define out 9 #define fan 10 int count=0; void setup() {   lcd.begin(16,2);   lcd.print("Visitor Counter");   delay(2000);   pinMode(in, INPUT);   pinMode(out, INPUT);   pinMode(fan, OUTPUT);   lcd.clear();   lcd.print("Person In Room:");   lcd.setCursor(0,1);   lcd.print(count); } void loop() {     int in_value = digitalRead(in);   int out_value = digitalRead(out);   if(in_value == LOW)   {     count++;     lcd.clear();     lcd.print("Person In Room:");     lcd.setCursor(0,1);     lcd.print(count);     delay(1000);   }   if(out_value == LOW)   {     count--;     lcd.clear();     lcd.print("Person In Room:");     lcd.setCursor(0,1);     lcd.print(coun...
Read more

How to interface Ultrasonic sensor with Arduino UNO (Arduino Series - Part 05)

-
Image
Display the results from the HC-SR04 Ultrasonic Sensor on an LCD Display Hardware Required: - Arduino Board - Ultrasonic Sensor HC-SR04 - LCD Display - 1k ohm resistor - Breadboard and wires Ultrasonic Sensor HC-SR04 Connections: - The HC-SR04 Ultrasonic Module has 4 pins, Ground, VCC, Trig and Echo. The Ground and the VCC pins of the module needs to be connected to the Ground and the 5 volts pins on the Arduino Board respectively and the trig and echo pins to any Digital I/O pin on the Arduino Board. - The HC-SR04 sensor attach to the Breadboard - The Sensor VCC connect to the Arduino Board +5V - The Sensor GND connect to the Arduino Board GND - The Sensor Trig connect to the Arduino Board Digital I/O 10 - The Sensor Echo connect to the Arduino Board Digital I/O 11 Look the basic tutorial about the HC-SR04  https://youtu.be/OFlt5vgCzZs LCD Display Connection: Before wiring the LCD screen to your Arduino or Genuino board ...
Read more

How to Make Call, Send and Receive Message using GSM Module

-
Image
AT Commands: Make a Voice call: ATD+91XXXXXXXXXX; Send Message: AT+CMGF=1 AT+CMGS=\"+91XXXXXXXXXX\"\r Message goes here (char)26 Receive Message: AT+CNMI=2,2,0,0,0 AT+CMGF=1 Redial call: ATDL ------------------------------------------------------------------------------------------------------ Arduino Code to make a Voice Call: void setup()  {  Serial.begin(9600);  Serial.println("ATD+91XXXXXXXXXX;");  delay(1000); } void loop()  { } ------------------------------------------------------------------------------------------------------ Arduino Code to send a Message: void setup()  { Serial.begin(9600); Serial.println("AT+CMGF=1"); delay(1000); Serial.println("AT+CMGS=\"+91XXXXXXXXXX\"\r"); delay(1000); Serial.println("Hello"); delay(1000); Serial.println("Himanshu"); delay(1000); Serial.println((char)26); } void loop()  { } -------------------...
Read more